Item ID: NIGHTWIRE
Currently Out of Stock
As low as $4.06 per month.
Buy a EarthQuaker Devices Night Wire Harmonic Tremolo for a limited time and be qualified to receive financing of 0% INTEREST for up to 48 MONTHS. Click here for more details.
Free Shipping on any order(s) above $9.99 (over-sized products not included)
Harmonic Tremolo Guitar Effects Pedal with Level, Rate, Depth, and Frequency Controls - 2-Way Rate Toggle and 3-Way Frequency Toggle Switch
The Night Wire is a feature-rich harmonic tremolo. What is harmonic tremolo? In short, the signal is split into high pass and low pass filters, then modulated with an LFO that is split 180 degrees. The Night Wire takes the traditional harmonic tremolo a few steps further by allowing the center point of both filters to be adjusted for different tones. The filter frequency has three modes: Manual, LFO and Attack. In Manual mode, the center point can be set to a fixed position with the frequency control. In LFO mode, the filters are continuously swept and the frequency control adjusts the speed. In Attack mode, the filters are dynamically swept according to pick attack and the frequency control acts as a range control, much like a standard envelope filter. The tremolo section has two modes, Manual and Attack. In Manual mode, the speed of the tremolo is governed by where the rate control is set. In Attack mode the speed is controlled by pick attack and the rate controls the sensitivity; the harder you pick, the faster the rate and vice-versa. The tremolo can be subtle and shimmery or full-on throbbing depending on where the depth control is set. With the depth set to zero, the Night Wire will act like a fixed filter, phase shifter or envelope-controlled filter depending on which mode the filter frequency is in. It also features a cut/boost volume control to get your levels just right. Each Night Wire is hand made one at a time in the moonlit village of Akron, Ohio.
This device is true bypass and uses relay based ‰ÛÏsoft touch‰ switching. Audio will not pass without power.
EQD pedals take a standard 9 volt DC power supply with a 2.1mm negative center barrel. EQD always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. Do not run at higher voltages!
|Pedal Type:||Harmonic Tremolo|
|Inputs:||1 x 1/4"|
|Outputs:||1 x 1/4"|
|Manufacturer Part Number:||EQDNIGH|