Item ID: 101000FC
Currently Out of Stock
As low as $3.64 per month.
Buy a Fairfield Circuitry The Barbershop Overdrive for a limited time and be qualified to receive financing of 0% INTEREST for up to 48 MONTHS. Click here for more details.
Free Shipping on any order(s) above $9.99 (over-sized products not included)
Have you ever sat in a barber's chair wishing your tone was as slick as your freshly shaved upper lip? With the Barbershop Overdrive on your pedalboard, you could keep your moustache and sound good doing it.
Less is more with this simple, original design. Handmade from JFETs matched to specs, this versatile pedal will treat your pickups with the respect they deserve. In return, they’ll thank you with some of them sweet tones.
The SAG control reduces the voltage to the amplifiers as you turn it counter clockwise, giving additional control over the character and feel of the saturation. The lower the SAG, the browner the sound. Full voltage is applied when the control is set to fully clockwise. It is at this setting that the pedal has the potential to be its cleanest and loudest.
A 3-position switch allows to select between different flavours of high cut. In the middle, there is no cut, like the classic Barbershop of days passed. To the right, a subtle high cut to tame ever so slightly the feeling of brightness accompanied with the Barbershop. To the left, a more extreme cut for those times when you want to delive into your dark side.
Sets the interstage gain of the amplifiers. More gain means more distortion. The wide operating range allows you to go from an almost clean gain to a tasty rich overdrive.
Controls the output volume of the pedal while keeping the effect unchanged. This is where you have plenty of room to boost.
The Barbershop Millenium Overdrive was designed to operate using your typical centre negative, regulated 9-9.6 VDC power supply. The pedal is protected against reversed polarity. The pedal will function with voltages up to 18 VDC but the character of the pedal will drastically change. The higher the voltage, the less drive you will have. Always check your power supply for proper voltage and polarity before connecting. There is no battery connection inside the pedal.